HP STORAGEWORKS P2000 MSA USB DRIVER

Thanks for sharing the information and hope it helps other readers. I am not a storage expert but I was the only one available to help bring back a customer online. Powering down the unit once more, removing and reseating both controllers did not help either. Page 54 – Replication setup and verification Page 55 – Diagnostics for replication setup: I have been looking for commands to try and found show vdisk, show volumes.

Uploader: Vot
Date Added: 28 December 2008
File Size: 18.88 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 77281
Price: Free* [*Free Regsitration Required]

Same Person answering question.

I Thank you as well for posting this solution. As we don’t know what array was set up or if any spare disks were mxa we don’t want to reseat the drive hoping for a miricle.

Solved: Gadget Serial v Driver for P – Hewlett Packard Enterprise Community

Removing one then booting up with this seemed to solve the problem, and at the end of the day all hardware was indeed p000. Hot plugging controller A back storaggeworks at this stage with the device powered on resulted in both controllers reporting a healthy status and all the disks and hardware being detected.

Got it, continue to print. Thank you so much for your post, I was really stuck on this one.

  CONEXANT HCF V90 DRIVER

Page 52 Page 53 – Isolating a controller module expansion Post a new question here Anonymous 2 February at Install driver for the USB connection. Windows customers should locate the downloaded jsb driver described in. Really helpful stuff made by this blog.

HP StorageWorks P2000 – Connecting to and Configuring

Just in case anybody else is stuck I found the command show shutdown-status really helpful in trying to find out the states of the controllers.

Enable the CLI port for subsequent communication. Linux customers should enter the command syntax provided in. Complete HP customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp. Enter the following command: Hi Kumar, Are you able to shutdown the entire enclosure and try a power cycle?

HP : Configuring MSA P2000 G3 SAN through CLI

For Linux systems, see. This will just be helpful as currently the vdisk comprises of 11 disks so storzgeworks to assume that 1 disk was assigned as a spare and is now in use because of the failed disk. After this the 24 disks were assigned and carved up into some vdisks usg be presented to our ESXi hosts! Suddenly it got stopped and no amber no light. Hi Sean, I have an identical setup I am trying to get going as well. Thanks for posting this resolution, I had the exactly same issue and tried all sort of HP user guide recommendations without success.

  IBM Z61M CARD READER DRIVER

Hi Sean, Thank you so much for your post, I was really stuck on this one. If you encounter problems communicating with your computer to the USB device, you isolate the problem to one of a FRU Posted by HelloFiji 2 years ago.

Enter text from picture: Hp storageworks fabric os v3. Anonymous 14 February at Use the provided USB cable to connect controller A to set network I am not a storage expert but I was the up one available to help bring back a customer online.

Leave a Reply Cancel reply Your email address will not be published. Point your browser to the managemnt IP of one controller http or https, depends on config.

Just adding my thanks.